Installation requirements for communication base station inverters

How do I install an inverter?

Install at an appropriate height for ease of viewing LED indicators and operating switches. The inverter(s) must be installed on a structure with a load-bearing capacity of >4 times the inverter weight. Install the inverter vertically or at a minimum back tilt of 10°. Forward installation or upside-down installation is prohibited.

Can CSI solar inverter be installed under load?

CSI Solar Co., Ltd. DO NOT DISCONNECT UNDER LOAD! Do not install the inverter on structures constructed of flammable, thermolabile, or explosive materials. Ensure the inverter is out of children's reach. The ambient temperature should be between -30°C~ 60°C. The humidity of the installation location should be below 100% without condensation.

What are the characteristics of different communication methods of inverters?

The characteristics of different communication methods of inverters are obvious, and the application scenarios are different. In order to better weave the underlying network of energy digitization and intelligent development, choose the most appropriate communication method according to local conditions.

How do I connect multiple inverters to a PV system?

When there is only one inverter in the PV system, connect the additional grounding cable to a nearby grounding point. When there are multiple inverters in the PV system, connect grounding points of all inverters and the PV array frames to the equipotential cable (according to the onsite conditions) to implement an equipotential connection.

When does an inverter enter a standby state?

The inverter enters the standby state when the input voltage ranges between 1,000V and 1,100V. The inverter returns to the running state once the voltage returns to the MPPT operating voltage range (200 to 1,000V). Make sure the maximum short circuit current on the DC side is within the permissible range.

What are the steps in energy storage installation?

The main steps are: to build the foundation, install the energy storage cabinets, install the battery and inverter, and wire it all. During the commissioning of an energy storage system, which tests does the team perform? System-wide joint commissioning.